lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• Based on the principle and process of laser transmission welding, the lap joint form was taken and the key technology and difficulty of welding were also considered.
  基于激光透射焊接的原理和过程，采取搭接接头形式进行焊接，同时焊接关键技术和难点也被考虑。
• Using boundary element method, the interfacial streeses of adhensive lap joint with either perfect or imperfect interface are studied.
  采用边界元法计算分析了具有理想界面和非理想界面的双板条胶合搭接连接的界面应力。
• A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
  将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。
• Finite element analysis on reliability design of adhesively bonded single lap joint
  基于有限元方法的单搭接接头可靠性设计
• Influence of Elastic Modulus of Adhesive on the Stress and Strain Distribution in Aluminium Single Lap Joint
  胶粘剂弹性模量对铝合金单搭接接头应力应变分布的影响
• However, further increasing of RE content would degrade the shear properties of the lap joint.
  而当稀土含量进一步增加时，焊点的强度及塑性均下降。
• The structure of intersecting Lap joint Between steel pipe has been widely applied in engineering project, such as Oil and gas pipelines, Pressure vessel and Various forms of pipe truss structure.
  工程中钢管与钢管的相贯搭接广泛的应用于油气管道、压力容器以及各种形式的管桁架钢结构中。
• The results indicate that good lap joint between aluminum and galvanized steel sheet can be made in appropriate parameters.
  试验结果表明，铝和镀锌钢能得到成形良好的搭接接头。
• Taking the form of lap joint as an example, the effect of final assembling deviation affect by the assembly sequence was analyzed by adopting the method of worse condition.
  以搭接接头形式为例，采用最坏情况法分析了装配顺序对最终装配偏差的影响。
• The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
  对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。